Trim/Tilt Pin Wrenches AMT0004-38mm x 4mm for Seastar, Four Stroke Yamaha V6

Description

Application--Fits for all Seastar Steering Cylinders, Trim and Tilt Caps on all Four Stroke Yamaha V6, Trim and Tilt Caps on Non-VMAX 2 Strokes (225-300hp), and Tilt Caps on the 2011-Current F150. This wrench is not compatible with VMAX.
Function--To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit .Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder
A Must Have--Usually, you will put a little drift into one of those holes in the trim and tilt caps with a hammer. Than,you destroy these cap ,you will thrown them away,which cost a about hundred bucks. So, you really need the pin wrench to help you finish that case with ease
High Quality Material--Made of high hardened 4140 impact grade steel,with silver oxide coating which is rust-resistance and durable to use.Better than OEM.
Satisfaction Guarantee: If you're not 100% satisfied with this pin wrench MT0004, simply return it for a full refund in 30 days, guarantee with 12 months’ warranty
Outboard Trim/Tilt Pin Wrench AMT0004-38mm x 4mm
Fits all Seastar Steering Cylinders, Trim and Tilt Caps on all Four Stroke Yamaha V6,
Trim and Tilt Caps on Non-VMAX 2 Strokes (225-300hp),
Tilt Caps on the 2011-Current F150.
NOTE: This wrench is not compatible with VMAX.
WHY YOU NEED THIS PIN WRENCH????
Usually,you will put a little drift into one of those holes with a hammer
Than,you destroy these cap ,you will thrown them away,which cost a about hundred bucks.
So, you really need the pin wrench to help you finish that case with ease
Come with sets of pins 4
MIN Pin Strength:
-180 ft-lb
Included:
6x 4mm pins;
Replacement Pins:
AMT0005 - S-4mm
Easy to Use
To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit .
Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder
Used with 1/2" socket drive
Replacement for Yamaha Factory Tool: YB-06175-2B